The work
Stump Grinding in Oak Ridge, TN
Short answer
Stump grinding in Oak Ridge chews the stump into chips a few inches below the ground, and because the grinder digs, Tennessee law calls for a Tennessee 811 locate request at least three working days, and no more than ten, before the work. HomeGuide's national figures are $120 to $400 for one stump, or $2 to $6 per inch of diameter (HomeGuide, checked Nov 22, 2026).
One independent local contractor can grind the stump when the tree comes down or on a later visit, and prices it after seeing the size, the ground and the access.
Why does a stump job start with Tennessee 811?
A grinder's cutting wheel works below the surface, among roots that often wrap around buried water, gas, power and cable lines. Tennessee's Underground Utility Damage Prevention Act requires notice "at least three (3) working days prior to the actual date of excavation or demolition" but "not more than ten (10) full working days prior to such time" (Tenn. Code Ann. §65-31-106, checked Nov 22, 2026). The state's underground utility damage prevention office puts it plainly: "Each person responsible for excavating or demolishing must obtain a locate ticket from TN811," and "There is no charge for requesting utility line markings" (Tennessee Public Utility Commission, damage prevention FAQ, checked Nov 22, 2026). When a contractor does the grinding, the contractor is the one excavating.
Tennessee 811 takes requests at 811 or (800) 351-1111, or online. Utilities mark their lines with paint, flags or stakes in a standard set of colors: red for electric, yellow for gas, orange for communications, blue for drinking water and green for sewer (Tennessee 811, checked Nov 22, 2026).
Tennessee 811 says "Facility operators may not locate or mark private underground facilities" (Tennessee 811, checked Nov 22, 2026). Lines you own, like a power feed to a detached garage, a gas line to a grill, sprinkler pipe or a dog fence, won't be marked. Tell the contractor where they run.
What is the grinder going to hit under an Oak Ridge stump?
Often rock. Much of Oak Ridge sits on ridges of cherty limestone and dolostone, with valleys of shale between them.
- On the ridges. The USDA's Fullerton series, a soil of ridges in the Southern Appalachian Ridges and Valleys, has a red gravelly clay subsoil with about 25 percent chert gravel in its typical profile (USDA, Fullerton series, checked Nov 22, 2026). The Bodine series, found on the same kind of ground in Tennessee, runs 60 to 75 percent chert below about a foot (USDA, Bodine series, checked Nov 22, 2026). On Chestnut Ridge, soil scientists working for Oak Ridge National Laboratory wrote that "The very high chert content in this formation made augering very difficult" (ORNL, Soils of Walker Branch Watershed, 1994).
- In the shale valleys. The Montevallo series, a shallow soil of the same region, reaches weathered shale or siltstone 10 to 20 inches down (USDA, Montevallo series, checked Nov 22, 2026). On ground like that, roots spread wide rather than deep.
Chert is hard flint-like rock. A grinder that hits it throws chips of stone and wears its teeth fast, which is one reason the contractor will want to see the stump before pricing it, and one reason to keep people, cars and windows well back while it runs.

Can a stump on a steep bank be ground?
Often, with the right machine. Grinders range from small walk-behind units to tracked machines, and the contractor picks one by the size of the stump, the width of your gate and the pitch of the ground. A stump on a bank too steep for any of them can be cut flush and left. Tell the contractor if the stump sits on a bank, beside a retaining wall or at the edge of a creek.
Grinding a stump is a small job, but regrading a hillside afterward may not be. Oak Ridge's stormwater chapter requires land disturbance permits for single and duplex residential lots, and the City Manager can call for an erosion control plan on lots with karst features, a lake or stream next to them, or "slopes exceeding fifteen percent (15%)" (Oak Ridge City Code §14-503(1)(e), checked Nov 22, 2026). The same section exempts "Any home gardens, home landscaping, or land preparation unless the possibility of erosion or stream siltation is such to necessitate a permit" (§14-503(4)(g), checked Nov 22, 2026). If a removal turns into reshaping a bank, ask the city first.
Grinding, digging out or leaving it?
- Grinding takes the stump and the top of the main roots below the surface and leaves a hole full of chips. The rest of the roots stay in the ground.
- Digging the whole root ball out takes an excavator and leaves a large hole. It is worth it mainly where something is being built on the spot.
- Cutting it flush and leaving it costs least. On a wooded slope it is often the sensible choice.
After grinding, many homeowners rake the chips out, fill the hole with topsoil and seed it. If you want a new tree in the same spot, plant it to one side of the old stump, out of the chips.

What does stump grinding cost?
| Item | Published figure | Source |
|---|---|---|
| One stump | $120–$400 | HomeGuide |
| Each additional stump | $30–$60 | HomeGuide |
| Per inch of diameter | $2–$6 | HomeGuide |
| Minimum service charge | $80–$160 | HomeGuide |
| Cleanup and chip disposal | $2–$4 per inch extra | HomeGuide |
| Root removal | $75–$150 per hour | HomeGuide |
| National average per job | $272 (range $131–$438) | LawnStarter, updated Oct 5, 2026 |
To size your own stump, measure straight across the widest part of the cut top at ground level. A 30-inch white oak stump at $2 to $6 an inch works out to $60 to $180 for the grinding alone at those rates, before any minimum, cleanup or travel. Rock in the soil, a slope or a tight gate can push the price higher.
Questions about stumps
How deep does grinding go?
Ask the contractor. A few inches below grade is enough for grass; a garden bed, a fence post or a paver patio over the spot needs it deeper.
Do the roots keep growing?
Some species sprout from roots after the trunk is cut. If shoots come up around the old spot, mow or clip them until they quit.
Can the stump be ground on the day the tree comes down?
Yes, if the 811 ticket was called in three working days ahead and the marks are in place. Plan the stump when you book the removal.
